Allen-Bradley 1734-IM4 User Manual page 178

186 Configure POINT I/O Modules in RSLogix 5000 Software
Rockwell Automation Publication 1734-UM001E-EN-P - July 2013
3. From the Configuration dialog, complete entries for Input Filter Time
(ms) for Off-On and On-Off for each point, referring to the table.
Feature Description
Channel Displays channels you use to set channel configuration parameters
Input Filter Displays Off to On or On to Off transition filter constant
Time
• A high signal must be present for this amount of time before the module
reports an On.
• a low signal must be present for this amount of time before the module
reports an Off.
• Enter a value in milliseconds.
• The default is 1 ms (1000 ms).
4. From the Configuration dialog, perform one of the following:
• Click another tab at the top of the dialog.
or
• Click OK to save changes and close the dialog.
or
• Click Cancel to return to default values.
or
• Click Apply to save changes you made on any of the dialogs and
continue to display the dialog, noting that you enable the Apply button
when you make changes to any of the dialogs.
Work with Dialogs for Digital Output Modules
Read this section to complete the Fault/Program Action and Configuration
dialogs for output modules. You typically select these dialogs from the General
dialog, when you add an output module with the following entries for
connection type:
• Data
• Rack Optimization
Enter values for the Fault/Program Action and Configuration dialogs based on
the following output modules:
• Without diagnostic status
• With overload diagnostic status
• With overload and open load diagnostic status
Enter Values on the Fault/Program Action Dialog
Enter values on this dialog to configure the module output state for output
modules when the controller mode changes to Program or Fault mode. To make
these entries, follow these procedures.