Allen-Bradley 1734-IM4 User Manual page 181

2. From the Configuration dialog, complete entries, referring to the table for
information about how to complete entries with No Load Detection.
Feature Description
Point Displays the channel numbers.
Latch Faults • Use to determine how a status bit acts after the cause of the fault is
removed.
• Use latching for tracking transient or momentary faults.
• You do not affect status LEDs when using latched alarms.
If You Select
Latch Faults
(checked)
Reset Latch Faults
(unchecked)
Auto Restart • The Reset mode defines the action of the output during a short circuit or
overload.
• A fault also occurs if you turn on an output when you do not apply field
power to it.
Select
Latched off (unchecked)
Auto restart (checked)
Point Fault • Select to clear latched alarms.
• A blue arrow denotes the use of explicit messaging.
3. At the top of the Configuration dialog, complete the header check boxes
for the following:
• No Load Detection
• Latch Faults
Rockwell Automation Publication 1734-UM001E-EN-P - July 2013
Configure POINT I/O Modules in RSLogix 5000 Software
Then
Alarm bits stay faulted if an alarm
occurs. Clear the fault by using the
clear latched alarm service for the
channel (Reset pushbutton).
Alarm bits reflect the present state.
If you want the output to
Shut off
Continually try to turn on
189