Table of Contents
Advertisement
182
Configure POINT I/O Modules in RSLogix 5000 Software
Rockwell Automation Publication 1734-UM001E-EN-P - July 2013
3. Choose the Connection tab at the top of the dialog.
4. Leave the following unchecked:
• Inhibit Module
• Major Fault On Controller If Connection Fails While in Run Mode
5. Complete the entry for Requested Packet Interval (RPI), if the field is
selectable, per the following table.
Adapter Configuration
Direct Connection
Rack Optimization
6. Choose Module Info to see a dialog that provides identification and status
information
7. See the appropriate sections of this appendix for information about the
following tabs and dialogs, which you see based on the module you added:
• Fault/Program Action
• Configuration
Value for PRI for Module Type
Digital
50 ms
RPI is not selectable
Hide quick links:
Advertisement
Table of Contents
