TDK-Lambda Genesys User Manual page 90

# Command
22 UVL?
23 AST n
24 AST?
25 SAV
26 RCL
27 MODE?
28 MS?
NOTES:
1. In Advanced Parallel mode (refer to Sec. 6.2.1), "n" is the total system current.
2. In Advanced Parallel mode, "MC?" returns the Master unit current multiplied by the number
of Slave units +1.
Description
Returns the setting "n" where "n" is the exact string in the user's "UVL n". When in Local
mode, returns the last setting from the front panel in a 4 digit string.
Sets the Auto-restart mode to ON or OFF.
AST 1 (or AST ON): Auto-Restart On.
AST 0 (or AST OFF): Auto-Restart Off.
Returns the string Auto-Restart mode status.
Saves present settings. The settings are the same as power-down last setting. These
settings are erased when the supply power is switched Off and the new "last settings" are
saved.
Recalls last settings. Settings are from the last power-down or from the last "SAV"
command.
Returns the Power Supply operating mode. When the Power Supply is On (OUT 1) it will
return "CV" or "CC". When the power supply is Off (OUT 0 or fault shutdown) it will return
"OFF".
Returns the Master/Slave setting. Master: n = 1, 2, 3, or 4; Slave: n=0
83532002 Rev C
84