TDK-Lambda Genesys User Manual page 56

Number Item
1 AC input
2 DC output
3 Remote-In
connector
4 Remote Out
connector
5 J1 Analog Remote
Program and
Monitor connector
6 SW1 Setup switch
7 J2 Remote sense
connector
8 Blank or Option
Plate
9 IEEE switch
LAN switch
10 Ground screw
Table 4-2: Rear Panel Connections and Controls
Description
M6x10mm Stud terminal suitable for ring lugs.
Bus-bars (7.5V < Vout < 300V models).
M6x10mm threaded-stud terminals (300V < Vout < 600V models).
RJ-45 type connector, use for connecting power supplies to RS-232
or RS-485 port of computer for remote control purposes. When
using several power supplies in a power system, the first unit
Remote-In is connected to the computer and the remaining units are
daisy-chained, Remote-In to Remote-Out.
RJ-45 type connector, used for daisy-chaining power supplies to
form a serial communication bus.
Connector for remote analog interface. Includes Output voltage and
current programming and monitoring signals, Shut-off control
(electrical signal), Enable/Disable control (dry-contact), Power
Supply OK (PS_OK) signal and operation mode (CV/CC) signal.
Nine position DIP-switch for selecting remote programming and
monitoring modes for Output Voltage, Current Limit and other
control functions.
Connector for making remote sensing connections to the load for
regulation of the load voltage and compensation of load wire drop.
Blank sub-plate for standard units.
Other plates and connectors for options such as LAN, IEMD or
Isolated Analog. IEEE connector for units equipped with IEEE
programming option (shown).
Two position DIP-switch for selecting option mode or RS-232/RS-
485 mode. The options may be LAN or IEEE.
M5 x 20mm screw for Chassis ground connection.
83532002 Rev C
50
Section
3.7
3.9
3.9.1
8.3
8.4
8.3
8.4
4.5
4.4.1
4.4
4.4.1
4.4.2
3.8.2
3.10.2
3.10.3
Fig. 4-2
Fig. 4-2
Fig. 4-2