Fig. 67 — Power Exhaust Damper Kit
4. Inspect box contents for missing or damaged parts. If
any parts are damaged or missing, contact your Carrier
representative for assistance.
5. Install gasket flush to each panel flange (top, bottom
and sides) as shown below. See Fig. 68.
Fig. 68 — Installing the Gasket
6. If a damper was ordered, install the gasket on the en-
tering and leaving side of the damper as shown. Note,
apply the gasket on both sides of the corner
(90 degrees) by bending the gasket. See Fig. 69.
Fig. 69 — Installing the Gasket on the Damper
7. First, attach side panels to return/exhaust fan opening
using the
1
/
in.-14 x
4
neoprene washers.) Then attach bottom panel using
similar sheet metal screws. See Fig. 70.
Fig. 70 — Attaching the Side Panels and Bottom
8. After attaching bottom panel to unit, attach bottom
panel to side panel using the
sheet metal screws (without neoprene washer). See
Fig. 71.
115
3
/
in. sheet metal screws (with
4
Panel
1
/
in.-14 x
5
/
in. long
4
8