Table of Contents
Advertisement
Safety
The user must
Obligations
•
have received training in operation of the circular metal saw,
of the user
•
know the function and principle of operation,
•
before the machine is first used
-
-
Additional
For work on the following machine components there are additional requirements:
qualification
•
Electrical components or devices: This work must only be carried out by a qualified electri-
require-
cian or person working under the instructions and supervision of a qualified electrician.
ments
Before carrying out work on electric components or operating units the following measures
must be taken, in the order given.
-
-
-
1.5
User positions
The user must stand in front of the circular metal saw.
INFORMATION
The mains plug of the circular metal saw must be freely accessible.
1.6
Safety measures during operation
CAUTION!
Risk due to inhaling of health hazardous dusts and mist.
Dependent on the material which need to be processed and the used auxiliaries dusts
and mist may be caused which might impair you health.
Make sure that the generated health hazardous dusts and mist are safely sucked off at
the point of origin and is dissipated or filtered from the working area. Use an appropriate
suction unit.
CAUTION!
Risk of fire and explosion by using flammable materials or cooling lubricants.
Take additional preventive measures in order to safely avoid health hazards before
processing flammable materials (e.g. aluminum, magnesium) or before using flammable
additives (e.g. spirit).
1.7
Safety devices
Use the circular metal saw only with properly functioning safety devices.
Stop the circular metal saw immediately if there is a failure in the safety device or if it is not func-
tioning for any reason.
It is your responsibility!
have read and understood the operating manual,
be familiar with all safety devices and regulations.
Disconnect all poles
Ensure that the machine cannot be turned on again
Check that there is no voltage
Page 9
Advertisement
Table of Contents
