Table of Contents
Advertisement
Operation
4.8
Cooling
ATTENTION!
Damage to the pump in the event of dry running.
When the circular metal saw is switched on the coolant pump is switched on.
The pump is lubricated by the coolant. Do not start up the pump without coolant.
Turn the dosing stop valve in direction of the coolant hose until the coolant penetrates.
By the turning move high temperatures are generated at the lip of the tool by the occurring fric-
tion heat.
By cooling with an appropriate coolant/lubricant agent you will achieve better working results
and longer tool life of the saw blade.
Filling quantity about
Illustration: 4-11: Coolant appliance
INFORMATION
Use a water-soluble and non-pollutant emulsion as a cooling agent. This can be acquired from
authorised distributors.
Make sure that the cooling agent is properly retrieved.
Respect the environment when disposing of any lubricants and cooling agents.
Follow the manufacturer's disposal instructions.
Page 30
Dosing stop valve
(Flow blocked)
Coolant hose
Advertisement
Table of Contents
