Palmgren CS 250 Operating Manual page 34

Maintenance
INTERVAL
as required
as required
as required
as required
Page 34
WHERE? WHAT?
adjust-
ing the
end
position
HOW?
Regularly remove the chips which are accumulating below
the clamping jaws.
To do so, use a thin, flat brush.
CAUTION!
Never clean the vice with compressed air.
• Lubricate the arbor of the bearing block
Illustration: 5-3: Bearing block
• Lubricate the spindle of the machine vice at the provided lubricat-
ing nipples.
Type of lubricating oil,
•
The end position of the saw blade shall be positioned below
the support face of the machine vice.
Adjust the end position of the saw head with the screw.
Refasten the counternut after readjusting it.
Mechanical end posi-
tion of the saw arch
adjusting screw
Illustr.5-4: end position saw arch
Lubricating nipple
Arbor
Bearing block
"Operating material" on page 16