Sawing Of Angles - Palmgren CS 250 Operating Manual

4.7

Sawing of angles

The circular metal saw can be turned from -45° to 45° in order to allow angular saw cuts.
Locking lever cutting angle
Illustration: 4-9: Setting of angle cut
CAUTION!
Make sure that the saw is clean and free of chips in the slewing area before adjusting it.
Loosen the locking lever.
Turn the saw to the required cutting position with the help of the angle scale.
Retighten the locking lever.
Move the locking lever to
the right in order to
release the bearing
block.
Adjust the saw to the
required position with the
help of the angle scale.
Move the locking lever to
the left in order to rec-
lamp the bearing block.
Angle scale
Operation
Page 29