Table of Contents
Advertisement
Device Boot
/dev/sda1
For USB storage:
Disk /dev/sdb: 30.9 GB, 30942946304 bytes
64 heads, 32 sectors/track, 29509 cylinders
Units = cylinders of 2048 * 512 = 1048576 bytes
Device Boot
3
Mount the device /dev/sdb to the /mnt/usb directory.
ONIE:/ # mount -t vfat /dev/sdb /mnt/usb
NOTE:
The following message displays if the /mnt/usb directory is missing: mount: mounting /dev/sdb
on /mnt/usb failed: No such file or directory.
NOTE:
The following message displays if the USB device is not seen: mount: mounting /dev/sdb on /mnt/usb
failed: No such device or address.
Before you install an OS
After powering on the Z9264F-ON switch, it goes through a power-on self-test (POST).
POST runs every time the switch is initialized and checks the hardware components to determine if the switch is fully operational before
booting. After POST, the switch uses the Grub bootloader.
To select an entry, use the up and down arrow keys. Press Enter to select an OS or enter e to edit the commands before booting. Enter c
for a command line. The selected entry runs automatically in the operating system.
Grub bootloader example
GNU GRUB
version 2.02~beta2+e4a1fe391
+-------------------------------------------------+
|*ONIE: Install OS
| ONIE: Rescue
| ONIE: Uninstall OS
| ONIE: Update ONIE
| ONIE: Embed ONIE
| EDA-DIAG
|
+-------------------------------------------------+
Your switch comes with ONIE installed.
NOTE:
To access ONIE, use the RJ-45 or MicroUSB console port.
ONIE example
ONIE: Install OS
For downloading and installing an OS from a URL
Starts ONIE with ONIE Discovery Service
(factory default boot)
ONIE: Rescue
Starts ONIE without ONIE Discovery Service
Useful for running Diagnostics manually
ONIE: Uninstall OS
Restore to factory defaults erases any installed OS
36
Management ports
Start
End
1
1925
Start
End
Blocks
Id System
15458303+ ee EFI GPT
Blocks
Id System
|
|
|
|
|
|
|
Advertisement
Table of Contents
