Table 11 Specification Of The Xrpad Ipu-2 - Varex Imaging XRpad2 4343 User Manual

XRpad2 4343
Table 11 includes the specification for the XRpad IPU-2.
Table 11 Specification of the XRpad IPU-2
Electrical Specification
AC Input Voltage [16]
AC Frequency [16]
DC Output [8]
Trigger In Signal from Hand Switch [6]
Trigger Out Signal to Generator [5]
Trigger In Signal [7, 9]
Trigger Out Signal [7, 10]
DC Output 5PF [7]
Protection Class:
Mechanical Specification
Size
Temperature Ranges
Operating
Transportation/Storage
Relative Humidity
Operating
Transportation/Storage
Ingress Protection Rating
IP40 rated (protection against particles > 1 mm)
All external signals that are connected to the XRpad IPU-2 (especially
WARNING
PREP/EXPOSE and Trigger signals) should be from a Separated or
Safety Extra-Low Voltage (SELV) circuit. Ignoring this warning may
result in electric shock, which may result in severe personal injury,
death, or substantial product damage.
The detector must not be used in a situation where it controls the X-ray
WARNING
dose delivered to the patient.
The trigger signals from the detector must not be the sole activation
WARNING
means for X-ray delivery, and must be used in association with other
control inputs: for example, a hand switch, safety interlocks, and a
means of controlling the beam duration.
100 V ... 240 V
50 Hz/60 Hz
13.5 V/5 A, 15 V/1 A
(voltage level is dependent of load)
5 V ... 24 V/10 mA (SELV)
Same level as Trigger In Signal
5 V (SELV)
5 V
5 V/40 mA
260 mm (L) × 205 mm (W) × 50 mm (H)
10°C to 35°C
–10°C to 70°C
10% to 90%
0% to 90%
www.vareximaging.com 25