Varex Imaging XRpad2 4343 User Manual page 5

XRpad2 4343
The detector is not designed to control X-ray dose. The system
WARNING
integrator is responsible for controlling the X-ray radiation.
Connection of the X-ray detector to the installed IT network that
WARNING
includes other equipment could result in previously unidentified risk
to patients, operators or third parties. the responsible organization
should identify, analyze, evaluate and control these risk. Subsequent
changes to the IT-network could introduce also new risks and require
additional analysis.
Do not operate the X-ray detector in a location with the following
Caution
conditions.
•
•
•
•
•
•
•
•
•
•
Ignoring this caution may result in personal injury or damage to
the product.
When using the X-ray detector in Automatic Exposure Detection
Caution
(AED) mode, the temperature may increase due to the heat generated
by the X-ray detector electronics to support the AED mode. Follow the
integration guide and instructions for the use of the X-ray detector in
AED mode. Ignoring this caution may result in personal injury or
damage to the product.
Monitor the temperature of the X-ray detector and allow the detector to
Caution
cool down when the temperature of the detector gets hot. Ignoring this
caution may result in personal injury or damage to the product.
An Image Quality Test or Customer Acceptance test should be
Caution
performed before the detector is used for the first time with patients.
Close to fluid or places where fluid is used
Close to heat sources, such as a heater
High temperature environment
High humidity environment
High condensation environment
Extreme cold environment
Dusty environment
Salty or sulphurous environment
Near a vibrating environment
Environment where there is insufficient air circulation to enable the X-ray
detector, and power supply to dissipate heat.
www.vareximaging.com
For Your Safety
v