Declarations; Guidance And Manufacturer's Declaration; Table 12 Guidance And Manufacturer's Declaration Of Electromagnetic Emissions - Varex Imaging XRpad2 4343 User Manual

14.0

Declarations

This section includes the manufacturers' declaration of standards and/or regulations for which
the product complies.
14.1

Guidance and Manufacturer's Declaration

Table 12 Guidance and Manufacturer's Declaration of Electromagnetic Emissions
Guidance and Manufacturer's Declaration of Electromagnetic Emissions
The X-ray detector is intended for use in the electromagnetic environment specified below. The installer,
X-ray system manufacturer, or user of the X-ray detector is responsible for the usage condition of the
detector to be within such environment.
Emissions Test
RF-emissions CISPR 11
RF-emissions CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
42
Compliance Electromagnetic Environment – Guidance
Group 1 The X-ray detector uses RF energy only for its internal
function; therefore, its RF emissions are very low and are
not likely to cause any interference in nearby electronic
equipment. Should any interference (EMC) be detected
with any other equipment, reposition the X-ray detector
or the other equipment away from each other.
Class B (wireless) The X-ray detector is suitable for use in industrial and
Class A (wired) installed environments in the wired mode.
Class B (wireless) In the wireless mode the X-ray detector is suitable for use
Class A (wired) in all environments within Class B.
Complies Should any interference (EMC) be detected with any other
equipment, reposition the X-ray detector or the other
equipment away from each other.
www.vareximaging.com
XRpad2 4343