Varex Imaging XRpad2 4343 User Manual page 6

For Your Safety
Interface and Power Unit and Cables
Be sure to turn OFF the power of the X-ray detector, including turning
WARNING
off the power supply or removing the battery (if applicable) before
servicing, maintaining, connecting, or disconnecting the cables or
accessories.
Do not touch the power supply, Battery Pack, X-ray detector, cable,
connector, or any other electrical component or equipment with wet
hands. Ignoring this warning may cause electrical shock, which may
result in severe personal injury, death, or substantial product damage.
Disconnect the cables by pulling on the connector and not the cable
WARNING
itself. Ignoring this warning may cause electrical shock, which may
result in severe personal injury, death, or substantial product damage.
Do not modify the cables or subject the cable to external stress or
WARNING
damage. Avoid placing anything heavy, including the detector, on the
cable, stepping on the cable, pulling the cable, or subjecting the cable
to excessive bending or bundling. Ignoring this warning may cause
cable failure resulting in electrical shock, which may result in severe
personal injury, death, or substantial product damage.
Do not turn ON the power supply or X-ray detector when
WARNING
condensation is on the X-ray detector or any of its components or
accessories. Ignoring this warning may cause electrical shock, which
may result in severe personal injury, death, or substantial product
damage.
To avoid risk of electric shock, this equipment must only be connected
WARNING
to a supply mains with protective earth.
vi www.vareximaging.com
XRpad2 4343