Table of Contents
Advertisement
XRpad2 4343
10.5.1.7 Disposing of the Battery Pack
To dispose of the battery pack:
•
The battery pack shall not be disposed with other waste at the end of its
working life.
•
Recycle or dispose the battery in accordance with local, state, and federal/national laws and
environmental regulations.
•
Do not place the battery in fire or incinerate.
•
For transporting, follow the requirements in
on page
21.
10.5.2
XRpad IPU-2
The XRpad IPU-2 is an Interface and Power Unit. The XRpad IPU-2 combines the Power Supply
Unit with additional communication and trigger interfaces. The tethered power and
communication cable is connected to the X-ray detector. The communication data are split inside
the XRpad IPU-2 into Gigabit Ethernet Interface, Detector Trigger Interface, Hand Switch and
Generator Interface, and Detector Push Button Interface. The Gigabit Ethernet Interface of the
XRpad IPU-2 is connected to the Imaging Workstation using a Cat 5e/6 cable. The maximum
cable length is 31 m. The AC cable must be connected to a properly grounded receptacle. The AC
cable is removable and will be plugged to an IEC connector. The XRpad IPU-2 must be
connected with a ground by the functional ground connector
tial of the hospital by the potential equalization connector
be near the XRpad IPU-2 and shall be easily accessible. To isolate the equipment electrically from
supply main on all poles simultaneously, the supply main switch
Connecting the XRpad IPU-2 LAN port directly to the installed
WARNING
computer network may disturb the IT environment.
1
5
6
2
3
4
Front Panel
Figure 10 XRpad IPU-2
"Section 10.5.1.4, Transportation and Storage"
7
9
10
12
8
11
www.vareximaging.com
(Figure 10
[14]) or with the poten-
(Figure 10
[15]). The socket outlet shall
(Figure 10
13 14 15
Rear Panel
[18]) must be used.
16 17
18
23
Hide quick links:
Advertisement
Table of Contents
