Varex Imaging XRpad2 4343 User Manual page 4

For Your Safety
Installation and Environment of Use
The X-ray detector is intended to be installed, maintained, and used by
WARNING
qualified professional personnel who are trained and qualified in the
installation, maintenance, and use of X-ray equipment.
Do not operate the X-ray detector in or around flammable gases, gas mixtures,
WARNING
liquids, chemicals, or other substances. Ignoring this warning may result in
explosion, fire, or electric shock, which may result in severe personal injury,
death, or substantial product damage.
The AED mode requires a sufficient X-ray dose rate to the detector
WARNING
surface to trigger image acquisition. The required dose rate can vary at
different use conditions. The system integrator must evaluate the AED
operation with the complete X-ray setup in order to secure the proper
image acquisition in AED mode.
Depending on conditions, including but not limited to, environmental
conditions, installation method, X-ray system setup, and subject to be
imaged, the use of AED mode may result in false trigger or no trigger
of X-ray image acquisition. The risk of false trigger or no trigger of
X-ray image acquisition must be assessed for the specific intended use
and application. For the most reliable image acquisition method, use
of the external or software trigger mode to synchronize with the X-ray
source is recommended.
Do not connect the X-ray detector or the interface-and-power unit
WARNING
(IPU-2) to any component or accessory other than the manufacturer's
specified components and accessories. Ignoring this warning may
result in explosion, fire, or electric shock, which may result in severe
personal injury, death, or substantial product damage.
Do not modify or alter the X-ray detector, its components, or
WARNING
accessories. Ignoring this warning may result in explosion, fire, or
electric shock, which may result in severe personal injury, death, or
substantial product damage.
The X-ray detector shall only be used with its approved Varex
WARNING
accessories and replacement parts. Product certification and warranty
are rendered void if any modification or alteration to the product is
made, or any instruction, warning, or caution is not followed. It is
important that the X-ray detector is not directly connected to the
installed network. Connection of the X-ray detector directly with the
installed computer network may disturb the IT environment. The
imaging workstation and the Wi-Fi access point must comply with
IEC 60601-1 or IEC 60950-1.
iv www.vareximaging.com
XRpad2 4343