Cleaning The X-Ray Detector; Disinfecting The X-Ray Detector - Varex Imaging XRpad2 4343 User Manual

XRpad2 4343
11.5.2

Cleaning the X-ray Detector

To clean the X-ray detector:
Turn off the X-ray detector and the power and communication tethered cable, if applicable.
1
Insert the XRpad2 Protective Insert into the battery compartment before cleaning or
2
disinfecting the detector.
Locate and read the cleaning instructions specified on the product label. Follow the product
3
instructions for cleaning.
If you are using a disinfectant other than those specified, we recommend
Note
you consult a specialist for the procedure for disinfection.
Dispense wipe from container.
4
Visually inspect the device. If soil is present, use a wipe to remove soil from the device
5
surface. Use multiple wipes, as applicable, to remove all visible soil.
Take care to remove soil from seams, joints, and other difficult-to-reach areas.
6
Dispose of each wipe used for cleaning.
7
If visible residue from the cleaning product is evident after air drying, remove residue with a
8
general isopropyl alcohol wipe, and let air dry.
11.5.3

Disinfecting the X-ray Detector

To disinfect the X-ray detector:
Turn off the X-ray detector and the power and communication tethered cable, if applicable.
1
Insert the XRpad2 Protective Insert into the battery compartment before cleaning or
2
disinfecting the detector.
Locate and read the cleaning instructions specified on the product label. Follow the product
3
instructions for cleaning.
If you are using a disinfectant other than those specified, we recommend
Note
you consult a specialist for the procedure for disinfection.
Wipe the entire surface of the target areas of the system until they are visibly wet with the
4
chemical solution. Target areas include any surface that was cleaned and/or any other
surfaces potentially contaminated during system use without visible soil.
Take care to wet seams, joints, and other difficult-to-reach areas.
5
www.vareximaging.com 39