2.7.3 Remove Riser 2
1.
Power off the compute module and disconnect the power cable(s).
2.
Remove the air duct.
3.
Loosen the 3 screws (See A )
4.
Pull and lift the riser straight up and out of the system (See B and C)
2.7.4 Install Riser 2
1.
Power off the compute module and disconnect the power cable(s).
2.
Remove the air duct.
3.
Align and insert Riser 2 into Riser Slot 2 (See A)
4.
Ensure that the Riser is all the way down and fully seated (See B)
Figure 51. Installing Riser 1
See section
2.3.1.
Figure 52. Removing Riser 2
See section
2.3.1.