System Software Updates And Configuration; Updating The System Software Stack; Using The Bios Setup Utility - Intel S7200AP System Integration And Service Manual

3 System Software Updates and Configuration

3.1 Updating the System Software Stack

The system includes a software stack to operate. This includes a BIOS, BMC firmware, ME firmware, and
FRU & SDR data. A default software stack is loaded during the system manufacturing process. However, it
may not be the latest available. For best operation and system reliability, it is highly recommended to
update the system software stack to the latest available.
The latest system software stack can be downloaded from Intel at the Intel web site
http://downloadcenter.intel.com.
At a minimum, after the initial configuration, the system's FRU and SDR data must be updated to ensure
that the embedded platform management subsystem is configured properly. The system's FRU and SDR
data is updated by running the FRUSDR utility. Properly loaded FRU and SDR data allows platform
management to monitor the appropriate system sensors which are used to determine proper system
cooling, best performance, and accurate error reporting. The FRUSDR utility is included in the platform's
System Update Package (SUP) which can be downloaded from the Intel web site referenced above. The
System Update Package will include full system update instructions.

3.2 Using the BIOS Setup Utility

This section describes how to access and navigate the embedded <F2> BIOS Setup utility. This utility can
be used to view and configure system settings that determine how the server operates.
Entering the BIOS Setup. Refer to the BIOS Setup Guide for all BIOS supported options.
To enter the BIOS Setup using a keyboard (or emulated keyboard), press the <F2> function key during
boot time when the OEM or Intel Logo Screen or the POST Diagnostic Screen is displayed.
At initial system power on, a USB keyboard will not be functional until the USB controller has been
initialized during the power on self-test (POST) process. When the USB controller is initialized, the system
will beep once. Only after that time will the key strokes from a USB Keyboard be recognized allowing for
access into the <F2> BIOS Setup utility.
The following message will be displayed on the Diagnostic Screen or under the Quiet Boot Logo Screen:
Press <F2> to enter setup, <F6> Boot Menu, <F12> Network Boot
After pressing the <F2> key, the system will eventually load the BIOS Setup utility and display the BIOS
Setup Main Menu screen.
Should serious system errors occur during the POST process, the regular system boot will stop and the
system will load the BIOS Setup utility and display the Error Manager screen. The Error Manager screen will
list and provide information about the specific boot errors detected.
No Access to the BIOS Setup Utility
If the BIOS Setup utility is not accessible by hitting the <F2> key or other described access methods, it
may be necessary to restore the BIOS default settings.
Navigating the BIOS Setup Utility
The BIOS Setup utility consists of several menu screens, each holding either informational fields and/or
configurable system setup options.
The bottom right portion of each menu screen provides a list of commands that are used to navigate
through the Setup utility. These commands are displayed at all times.