Figure 35. Disconnect The Pump Cable (Fan Header J6J2); Figure 36. Remove Lacc Brackets #1 - Intel S7200AP System Integration And Service Manual

1. Power off the compute module and disconnect the power cable(s).
2. Remove the air duct.
3. Disconnect the pump cable that is connected to the 4-pin CPU Fan Header (J6J2)
4. Next, remove the LACC Heat Exchanger retaining brackets by removing the 4 screws.
See section 2.3.1.

Figure 35. Disconnect the Pump Cable (Fan Header J6J2)

Figure 36. Remove LACC brackets #1