Sony PMW-200 Service Manual page 47

4. Remove the outside panel assembly. (Refer to
5. Remove the top panel assembly. (Refer to
6. Remove the front panel assembly. (Refer to
Procedure
1. Remove the two screws to detach the SW-1559 board.
2. Disconnect the harness from the connector CN104 on the SW-1559 board.
3. Remove the two screws to detach the SW-1573 board.
4. Disconnect the flexible flat cable from the connector CN100 on the SW-1573 board.
Tapping screws
(2 x 5)
SW-1573 board
Slide switch
Front panel assembly
Note
Align the phase of the slide switch on the SW-1573 board and the knobs on the front panel assembly during
installation.
5. Install the removed parts by reversing steps of removal.
PMW-200/PMW-EX280
"2-5-1. Outside Panel
"2-6. Top Panel Assembly".)
"2-8-1. Front Panel
Flexible flat cable
CN100
SW-1559 board
Knob
Assembly".)
Assembly".)
Tapping screw
(2 x 5)
CN104
Tapping screw
(2 x 5)
Harness
2-17