Sony PMW-200 Service Manual page 76

3. Remove the inside panel assembly. (Refer to
4. Remove the outside panel assembly. (Refer to
5. Remove the top panel assembly. (Refer to
6. Remove the SxS slot assembly. (Refer to
7. Remove the front panel assembly. (Refer to
8. Remove the rear panel assembly. (Refer to
9. Remove the IO-255 assembly. (Refer to
10. Remove the main heat spreader DCP. (Refer to
11. Remove the handle assembly. (Refer to
Procedure
1. Disconnect the harness from the connector CN100 on the DC-167 board.
2. Remove the two precision screws (M2 x 4) to detach the DC-167 board.
3. Disconnect the harness from the connector CN100 on the PSW-97 board.
4. Remove the two precision screws (M2 x 4) to detach the PSW-97 board.
CN100
DC-167 board
Precision screws
(M2 x 4)
5. Install the removed parts by reversing steps of removal.
PMW-200/PMW-EX280
"2-4-1. Inside Panel
"2-5-1. Outside Panel
"2-6. Top Panel
"2-7-1. SxS Slot
"2-8-1. Front Panel
"2-9. Rear Panel
"2-11. IO-255
"2-12. DCP-56
"2-13-1. Handle
Harness
CN100
Harness
Assembly".)
Assembly".)
Assembly".)
Assembly".)
Assembly".)
Assembly".)
Board".)
Board".)
Assembly".)
Precision screws
(M2 x 4)
PSW-97 board
2-46