Battery Case; Battery Case Assembly; Dc-167 Board/Psw-97 Board - Sony PMW-200 Service Manual

2-15.

Battery Case

2-15-1.

Battery Case Assembly

Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer to
3. Remove the inside panel assembly. (Refer to
4. Remove the outside panel assembly. (Refer to
5. Remove the top panel assembly. (Refer to
6. Remove the SxS slot assembly. (Refer to
7. Remove the front panel assembly. (Refer to
8. Remove the rear panel assembly. (Refer to
9. Remove the IO-255 assembly. (Refer
10. Remove the main heat spreader DCP. (Refer to
11. Remove the handle assembly. (Refer to
Procedure
1. Disconnect the harness from the connector CN202 on the RE-298 board.
2. Disconnect the harnesses from the connectors CN100 and CN101 on the RE-299 board.
3. Remove the four precision screws (M2 x 5) to detach the battery case assembly.
4. Remove the two tapping screws (2 x 5) to detach the DC bracket from the battery case assembly.
CN202
RE-298 board
CN100
RE-299 board
5. Install the removed parts by reversing steps of removal.
2-15-2.

DC-167 Board/PSW-97 Board

Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer to
PMW-200/PMW-EX280
"2-2. Lithium Battery".)
"2-3. Bottom Cover and Tripod
"2-4-1. Inside Panel
"2-5-1. Outside Panel
"2-6. Top Panel
"2-7-1. SxS Slot
"2-8-1. Front Panel
"2-9. Rear Panel
to"2-11. IO-255
"2-12. DCP-56
"2-13-1. Handle
DC-167 board
DC bracket
CN101
RE-299 board
"2-2. Lithium Battery".)
"2-3. Bottom Cover and Tripod
Washer".)
Assembly".)
Assembly".)
Assembly".)
Assembly".)
Assembly".)
Assembly".)
Board".)
Board".)
Assembly".)
Tapping screws
(2 x 5)
PSW-97 board
Precision screws
(M2 x 5)
Battery case assembly
Harness
Harness
Harness
Washer".)
Precision screws
(M2 x 5)
2-45