Au Volume Block; Swc-54 Board/Ec-75 Board - Sony PMW-200 Service Manual

2-7-2.

AU Volume Block

Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer to
3. Remove the inside panel assembly. (Refer to
Procedure
1. Remove the precision screw (M2 x 5).
2. Disconnect the AU volume block from the connector CN102 on the SWC-54 board.
3. Install the removed parts by reversing steps of removal.
2-7-3.

SWC-54 Board/EC-75 Board

Preparation
1. Remove the battery lid. (Refer to
2. Remove the bottom cover. (Refer to
3. Remove the inside panel assembly. (Refer to
4. Remove the outside panel assembly. (Refer to
5. Remove the top panel assembly. (Refer to
6. Remove the SxS slot assembly. (Refer to
Procedure
1. Disconnect the flexible board from the connector CN102 on the SWC-54 board.
2. Remove the two (a) precision screws (M2 x 4) to detach the AU hold plate.
3. Remove the tapping screw (2 x 5) to detach the escutcheon.
4. Disconnect the harness from the connector (CN100) on the SW-1575 board.
5. Remove the three (b) precision screws (M2 x 4).
PMW-200/PMW-EX280
"2-2. Lithium Battery".)
"2-3. Bottom Cover and Tripod
"2-4-1. Inside Panel
SWC-54 board
AU volume block
Precision screw
(M2x 5)
CN102
"2-2. Lithium Battery".)
"2-3. Bottom Cover and Tripod
"2-4-1. Inside Panel
"2-5-1. Outside Panel
"2-6. Top Panel Assembly".)
"2-7-1. SxS Slot Assembly".)
Washer".)
Assembly".)
Washer".)
Assembly".)
Assembly".)
2-14