Basic Settings - Wiznet W7500S2E-R1 User Manual

•
Flow Control: Shows the flow control settings, default: NONE *
* These settings could be updated in the "Basic Settings"

7.2 Basic Settings

Figure 7-4 shows W7500S2E-R1 basic settings page. It is separate into four sections; The
following paragraph talking about each section.
Network Setting
•
MAC Address: Shows MAC address provided with the module, user cannot modify
•
Use DHCP: DHCP mode option, default: uncheck
•
IP address: Shows the IP address, default: 192.168.1.88
•
Subnet Mask: Shows the Subnet Mask, default: 255.255.255.0
•
Gateway: Shows the Gateway, default: 192.168.1.1
•
DNS Server: Shows the DNS address, default: 114.114.114.114
Socket Setting
•
Start Mode: Startup mode of the module, it could be "AT Command Mode" or "Data
Mode" #
•
Socket Type: The module's operating mode: There are 3 types to use. TCP server, TCP
client and UDP mode
•
Remote Host: Shows remote host IP address, default: 192.168.1.99; It accepts IP address
or domain name inputs
•
Remote Port: Shows remote host port number, default: 5000
•
Local Port: Local port number, default: 5000. The value range is 0 to 65535 (Port 80 has
used for web port. Please avoid using this port number.)
•
Bind Local Port: Binding Local Port option, default: uncheck, only available on TCP
#
client mode
UART Setting
Baud Rate: The baud rate option, default: 115200, between 1.2Kbps to 1.152Mpbs
Data Bit: The data bit option, default: 8, it could set into 7 or 8 bits
W7500S2E-R1 user manual
W7500S2E-R1 serial to Ethernet module
Figure 7-4 Basic setting page
#
37
#
#
#
#
#
#
#
#
#