Wiznet W7500S2E-R1 User Manual page 2

V1.0 2017-09-19
V1.1 2018-05-30
Document Revision History
Copyright notice
Copyright © WIZnet H.K. Ltd. All rights reserved.
Contact E-mail: supports@wiznet.hk
For more information, please visit:
W7500S2E-R1 user manual
First release
Description of AT+NETBIOS command is revised
1.
Parameters of AT+C1_STOPB command is changed to 0:1, 1:2
2.
Maximum length of the AT+C1_SER_T command parameter is changed to 5, value
3.
range is changed to 0~60000
Parameter of the Terminal check (AT) query command is removed
4.
Replace all " " in the text with "\r\n"
5.
/n/r
Maximum length of the AT+C1_BIND command parameter is changed to 1
6.
Maximum length of the AT+C1_TCPAT command parameter is changed to 3
7.
Description of the AT+NAME command is updated
8.
Chapter 2.2: Pin 2 of SW3 description in changes from GND to Vcc; picture has also
9.
been modified
10. Updated Figure 2-4 Evaluation Board Reference Design Schematic
11. Maximum length of the AT+MAC command parameter is removed
12. Stop Bit is changed to 1, 2 in the specification
13. Power supply is changed to DC 3.3V in the specification
14. Chapter 1.2.2: "upper and lower parts" is changed to "left and right"
15. Chapter 7.2: Baud Rate and Stop Bit is revised
16. Chapter 7.3: Device Name has maximum length 15 bytes
17. Chapter 7.4: Password has maximum length 15 bytes
18. Power supply is changed to DC 3.3V
19. Maximum length of the AT+DEFAULT and AT+RESET command parameters in the
list of AT commands is modified to 15
20. Default value of AT+DEBUGMSGEN parameter is modified to 1
21. Chapter 5.3, WIZS2E ConfigTool new function introduction is added
22. All WIZS2E ConfigTool screen captures are updated
http: //www.wiznet.com.hk/
W7500S2E-R1 serial to Ethernet module