Ip Address; Module Ip Address Factory Default Settings; Method To Get The Ip Address Of The Module - Wiznet W7500S2E-R1 User Manual

W7500S2E-R1 serial to Ethernet module

4 IP address

Before using the module, we need to know some parameters like IP address. This module
support "Static" and "DHCP" IP collection method. For "Static" mode, user could manually
change the IP address, subnet mask & gateway parameters. The emphasis here is that the IP
address of the module cannot be the same as the IP address of other devices in the same LAN. i.e.
the module will activate DHCP protocol to collect IP address, subnet mask and gateway
information from the DHCP server.

4.1 Module IP address factory default settings

WIZS2E Serial to Ethernet module's factory default IP address: 192.168.1.88.

4.2 Method to get the IP address of the module

No matter forgotten the IP address of the module or the module is working on DHCP mode, the
current IP address of the module could be searched using the WIZS2E ConfigTool. The
following steps are the method to use WIZS2E ConfigTool to search the IP address for WIZS2E
module:
1. Connect the host computer and the module with LAN cable and power up the module.
2. Run the WIZS2E ConfigTool and it shows as the following 4-1 figure.
Figure 4-1 WIZS2E ConfigTool interface
3. Press button, it shows the IP address information as the following figure 4-2.
W7500S2E-R1 user manual
10