Wiznet W7500S2E-R1 User Manual page 30

available for TCP client and UDP mode.
6.4.3.14 DNS server address (AT+DNS)
Command format
AT+DNS=<dns>\r\n
AT+DNS?\r\n
Return value
DNS server address format is separate in 4 sections; each section is a decimal value and using a dot to separate.
The value range for each section is 0-255 therefore the maximum value size for DNS server address is 15 bytes.
This command could not accept xxx.xxx.xxx.0 or xxx.xxx.xxx.255 values input.
6.4.3.15 Debug message (AT+DEBUGMSGEN)
Command format
AT+DEBUGMSGEN=<debugmsg>\r\n
AT+DEBUGMSGEN?\r\n
Return value
6.4.3.16 MAC address (AT+MAC)
Command format
AT+MAC?\r\n
Return value
This is the MAC address of this WIZS2E. This attribute is read-only.
6.4.3.17 IP setting method (AT+IP_MODE)
Command format
AT+IP_MODE=<mode>\r\n
AT+IP_MODE?\r\n
Return value
When using static IP mode, the IP address, gateway, subnet mask and DNS server address are required configure
by user. In DHCP mode, W7500S2E-R1 will get all above IP parameters from the DHCP server.
6.4.3.18 Web port number (AT+WEB_PORT)
Command format
AT+WEB_PORT=<port>\r\n
AT+WEB_PORT?\r\n
Return value
This port number will be used on W7500S2E-R1's webserver through web browser. The value range is 0 to
65535. If the port wasn't set to 80, it needs to add the port number at the end of IP address. For example:
192.168.1.88: 8000.
W7500S2E-R1 user manual
Parameters
<dns>
DNS server address, default: 114.114.114.114
[DNS] Value is: <dns>\r\nOK\r\n
<debugmsg>
0: Turn off the print debugging information;
1: Turn on print debug information (default)
[DEBUGMEGEN] Value is: <debugmsg>\r\nOK\r\n
Parameters
Nil
[MAC] Value is: <mac>\r\nOK\r\n
Parameters
<mode>
0: Static IP mode (default)
1: DHCP mode
[IP_MODE] Value is: <mode>\r\nOK\r\n
Parameters
<port>
Web server port number, default: 80
[WEB_PORT] Value is: <port>\r\nOK\r\n
26
W7500S2E-R1 serial to Ethernet module
Parameters
Usage
Define new value
Query current value
Usage
Define new value
Query current value
Usage
Query current value
Usage
Define new value
Query current value
Usage
Define new value
Query current value