Table of Contents
Advertisement
Chapter 2 Preparations
1.9.3
Installation
Install a DIMM by using the following procedure.
1.
See steps 1 to 4 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Lift the duct off the server.
3.
Open both levers of the target DIMM slot
outward and push the DIMM straight into
the socket.
When the DIMM is inserted correctly, the
lever automatically closes.
4.
Attach the duct.
5.
Assemble the server.
6.
Turn on the server and confirm that no error messages are displayed in POST screen.
If any error messages are displayed, see Chapter 3 (1. POST Error Message) in "Maintenance Guide".
7.
Run the BIOS Setup Utility. On the Advanced menu, choose Memory Configuration, Memory
Information. Make sure the capacity of added DIMM is displayed properly.
See Chapter 2 (1. System BIOS) in "Maintenance Guide".
8.
On the Advanced menu, choose Memory Configuration, Memory Retest and then specify Yes.
Choose Save Changes and Exit to restart.
9.
Set the paging file size to the recommended value (Total memory size x 1.5) or more.
When using a Windows OS, see Chapter 1 (6.1 Specifying Memory Dump Settings (Debug
Information)) in "Installation Guide (Windows)".
For other OS, see the manual provided with the operating system or contact your sales representative.
Important
• Align the notch on the DIMM with the key on the slot.
• Do not apply too much pressure when you push a DIMM into the socket.
Express5800/R110f-1E User's Guide
1. Installing Internal Optional Devices
Notch
Key
59
Advertisement
Table of Contents
