Table of Contents
Advertisement
Chapter 3 Setup
1.
Turning on the Server
Turn on the server by using the following procedure.
1. Turn on the peripheral devices such as display unit.
2. Remove the front bezel.
3. If POWER LED lights amber, wait until POWER LED is unlit.
4. Press POWER Switch at the front of the server.
POWER LED is turned on green and after a while, NEC logo appears on the display.
While NEC logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the hardware.
For details, see Chapter 3 (1.1.1 POST sequence).
124
Tips
After connecting the power cord or turning off the server, wait for at least 30
seconds before pressing the POWER switch when the server is OFF.
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
Important
Do not turn off the server until NEC logo and some characters are displayed.
POWER LED
Express5800/R110f-1E User's Guide
POWER Switch
1. Turning on the Server
Advertisement
Table of Contents
