Table of Contents
Advertisement
Chapter 2 Preparations
(2) Removal procedure
Remove the server from the rack in the following procedure. It is recommended more than one person work
on this together.
1.
Turn off the server, and then disconnect the power cord and all cables from the server.
2.
Unlock the front bezel and remove it.
3.
Slowly pull the server out while pressing
the unlock buttons located on either side
of the front of the server.
4.
The server will come to a stop halfway.
Press and hold the stoppers on the rails
and pull the server out of the rack.
5.
Hold the server firmly and remove it from the rack.
Important
Be careful not to get your fingers caught in the rails and levers.
Important
• While more than one person is supporting the bottom part of the server,
slowly pull out the server.
• Do not apply pressure on the server from top when it is being pulled out.
Express5800/R110f-1E User's Guide
2. Installation and Connection
Key slot
Press the button
to unlock
Stopper
115
Advertisement
Table of Contents
