Assembly Sliding Table-Fixing And Handle; Fine Adjustment Of The Sliding Table; Mounting Bracket - Holzmann TS 250F User Manual

Table of Contents

Advertisement

Available languages

Available languages

12.2.2

Assembly sliding table-fixing and handle

Screw the sliding table fixation A visible with the included M12 nut, as in the following image.
The handle L to move the sliding table can be fixed by turning clockwise with the previously in-
serted into the T-slot nut K (see figure below)
12.2.3

Fine adjustment of the sliding table

The sliding table must be set so that the main
table and the surface of the sliding table of the
same height. The aluminum sliding table itself
can be slightly adjusted with the two locking
screws of the sliding table shots in height.
12.2.4

Mounting bracket

Unpack the frame A and the supporting arm B of the
sliding table arm from the packaging and screw them
ready with 2 thumbscrews as the following
Then the boom to the aluminum profile of the sliding
table must be secured with two thumbscrews
two lock nuts M20 must be screwed onto the threads
of the support
arm.
ment of the
boom.
Now hang the support arm into the sliding table
guide and adjust it in height by means of the
locknut
system.
The boom must be in level with
the main table and the aluminum
you have made this setting, fix the lock nuts
(M20)
accordingly.
HOLZMANN Maschinen Austria
They are used for height adjust-
profile.
www.holzmann-maschinen.at
image.
D.
The
Once
Strana 33
Formátovací pila / Panel saw TS 250F

Advertisement

Table of Contents
loading

Table of Contents