Operation - Holzmann TS 250F User Manual

 The 8 screws of the table insert (a) remove and remove it. -Fig.1-
 Loosen the screw (a) and the riving knife (b) at a distance of about
3mm - 8mm adjust the saw blade. -Fig. 2-
 The riving knife can be preset with the grub screw c .
 Pull the riving knife with the screw (a) firmly.
 Attach the blade guard cover back on the riving knife.
NOTE: This procedure should be repeated every time the when the saw blade is replaced.
14

OPERATION

14.1 Saw blade start / stop
If you want to press the ON OFF switch, the combined
EMERGENCY STOP switch must be in the open state.
 To start, press the green button ˝ I ˝
 To start, press the red button ˝ O ˝
INFO: In the closed state of the main switch can be operated as an EMERGENCY STOP switch.
14.1.1 Saw blade height adjustment
To adjust the height of the saw blade to the material it
is adjusted with the handwheel A.
The handwheel A clockwise to the blade upward to lift.
Rotate left lower to it.
The blade should protrude about 5 mm from the work-
piece.
14.1.2 Setting interface / tilt angle blade
 The clamping screw for locking screw.
 To the saw blade from the inclination 90° - 45° is
the handwheel B . -Fig.3-
 The clamping screw afterwards retighten.
HOLZMANN Maschinen Austria www.holzmann-maschinen.at
C
A B
Formátovací pila / Panel saw TS 250F
clamping screw
Fig. 3
Strana 38