Mounting The Saw Blade Guard - Holzmann TS 250F User Manual

Table of Contents

Advertisement

Available languages

Available languages

12.2.11

Mounting the saw blade guard

Assemble the blade guard (a) to the riving knife (b)
12.2.12
Connection suction
1. Dust collection ports are located on the chip case and blade
guard.
2. Fit the small ejection tube on blade guard.
3. From the hole of table saw rear panel, pull out the chip
ejection tube.
4. Fit the chip ejection tube onto three-way tube.
5. Fit the chip ejection tube of blade guard on three-way tube.
6. Then fit the main chip ejection tube to Dust collector.
Please note that the prosecution is only recommended outdoors without using a suction system.
In addition, without the required suction removal of chips can not be guaranteed and must there-
fore, after every 30min Operating be cleaned (particularly inside the machine), the machine
chips.
HOLZMANN Maschinen Austria
www.holzmann-maschinen.at
Strana 36
Formátovací pila / Panel saw TS 250F

Advertisement

Table of Contents
loading

Table of Contents