Mounting The Ruler; Mounting Clamping Plate; Mounting On-Off Switch; Mounting Table Extension - Holzmann TS 250F User Manual

12.2.5

Mounting the ruler

Take the extractable stop rail (A) from the
sliding carriage carton and put it onto the
sliding table frame, with the positon pin (B)
in the hole at the corner of the sliding table.
Set it verticle to the sliding carriage and fix it by
fasten the wing screw (C) beneath.
Attach the flip stop (D) to stop rail (A) and fix it
by the wing screw.
12.2.6

Mounting clamping plate

Place the clamping plate (A) on the sliding car-
riage and fix it by knuled screw B .
12.2.7

Mounting ON-OFF switch

Insert the supplied gasket into the designated re-
cess on the switch and screw the switch on the
housing of the machine with 4 M4x60 screws.
12.2.8

Mounting table extension

Screw the eight M8x30 Allen - screws on the sides, in the provided screw holes, so that each
about 10mm protrudes.
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Strana 34
Formátovací pila / Panel saw TS 250F