Electrical Connection - Holzmann TS 250F User Manual

12.3

Electrical connection

12.3.1 Earthing connection
When working on an ungrounded machine:
Serious injury due to electric shock in the event of a malfunction possible!
Therefore:
Machine must be grounded and be connected to a grounded outlet

 The electrical connection of the machine is ready for operation on a grounded electrical outlet!
 The plug must be connected only to a properly fitted and grounded electrical outlet!
 The supplied plug must not be changed. If the plug does not fit or is defective, only a qualified
electrical engineer may modify or replace these plugs!
 The grounding conductor is green-yellow!
 In the event of repair or replacement of the grounding conductor must not be connected to an
under voltage can!
 Check with a qualified electrician or service that the grounding instructions are understood and
the machine is grounded!
 A damaged cable must be replaced immediately!
13 OPERATION
13.1 Adjustments before initial
 Before any adjustments, the machine must be disconnected from the power supply to avoid
the risk of accidental switching on the machine!
 Check that the set speed for the saw blade used is not too high.
 Span only saw blades with a diameter of 200 mm.
13.1.1 Setting the riving knife
 Remove the blade guard cover from the riving knife
HOLZMANN Maschinen Austria
Fig. 1
www.holzmann-maschinen.at
A T T E N T I O N
Strana 37
Formátovací pila / Panel saw TS 250F
Fig. 2