Table of Contents
Advertisement
Choosing option 1 from the Calibration Selection Screen will display the AUTO
CAL screen shown below. The displayed mode may vary depending on the
instrument version and/or previous selections and also for GA2005H and
GA2005S Excieo models, MODE selection using Soft Key 4 is not possible.
26:08:11
AUTO CAL
Range: 0.02 – 100 ms
1. X:
9.986
2. Y:
0.130
3. Z:
0.130
Cal To: 10.00 ms
Press number of axis
EXIT
CAL TO
Figure 87 – Automatic Calibration (Type H)
For the multi-purpose Excieo variation, use Soft Key 4 labelled MODE to display
a popup which allows the selection of the available modes. Press Soft Key 4
labelled CANCEL to return to the previous screen without changing the
calibration mode otherwise press 1, 2, 3 or 4 depending on which mode /
transducer you wish to calibrate.
26:08:11
AUTO CAL
Range: 0.02 – 100 ms
1. X:
9.986
2. Y:
0.130
3. Z:
0.130
Cal To: 10.00 ms
Press number of axis
Figure 88 – Automatic Calibration Mode Selection
To reset all displayed axes measurements press Soft Key 3 labelled RESET.
The 'Cal To' figure displayed can be changed by selecting Soft Key 2 labelled
CAL TO. If selected then the 'Cal To' figure will be blanked and you will be
required to enter a new value using the numeric keypad. The 'Cal To' figure is
the value outputted from your calibrator in m/s
the calibration certificate of your calibrator.
09:44:00
HARM
-2
-2
RESET
09:44:05
HARM
-2
1. HARM
2. WBV
3. Single
-2
4. Custom
CANCEL
Page 75
26:08:11
AUTO CAL
Range: 0.02 – 100 ms
1. X:
9.986
2. Y:
0.130
3. Z:
0.130
Cal To: 10.00 ms
Press number of axis
EXIT
CAL TO
Figure 86 – Automatic Calibration (Type M)
. This figure can be found on
-2
09:44:02
HARM
-2
-2
RESET
MODE
Advertisement
Table of Contents
