Option 5 – Criterion
Whilst in Custom Mode it is possible to change all the legislative criterion levels
as listed below: -
EAV
Exposure Action Value
ELV
Exposure Limit Value
VDV EAV
Vibration Dose Value Exposure Action Value
VDV ELV
Vibration Dose Value Exposure Limit Value
Action Values
The point at which vibration exposure levels requires controlling to reduce the
risk to employees.
Limit Values
The maximum value that vibration exposure levels must not exceed.
Press 1 to toggle Criterion ON/OFF.
Press 2 to enter a new Exposure Action Value.
Press 3 to enter a new Exposure Limit Value.
Press 4 to enter a new VDV Exposure Action Value.
Press 5 to enter a new VDV Exposure Limit Value.
26:08:11
1. Criterion:
2. Action:
3. Limit:
4. VDV Action:
5. VDV Limit:
CANCEL
Figure 47 – Custom Mode Criterion Selection
Enter the new value using the numeric keypad, for example enter 0250 for a
value of 2.50. The decimal point is applied automatically.
Use the Left Arrow key
accept the inputted value. An Invalid input will give an 'Out of Range' error
message.
Press Soft Key 1 labelled CANCEL to discard any changes or Soft Key 4
labelled APPLY to make any changes made.
Maximum inputs for each selectable display unit / dB reference are shown in
the following tables: -
09:16:00
CRITERION
ON
0.50 ms
-2
1.15 ms
-2
9.10 ms
-2
21.00 ms
-2
APPLY
to delete unwanted input or press the OK key to
Page 46
26:08:11
1. Criterion:
2. Action:
3. Limit:
4. VDV Action:
5. VDV Limit:
Press OK to accept
CANCEL
Numeric Entry Prompt
09:16:02
CRITERION
ON
_ . ms
-2
1.15 ms
-2
9.10 ms
-2
21.00 ms
-2