Table of Contents
Advertisement
Option 1 (Page 2) – Correction Factor
A correction factor is a multiplying factor that is applied to each axis individually.
By default the X and Y axis have a correction factor of 1.4 whereas the Z axis
has a correction factor of 1.0.
Press 1 on the keypad to enter the X Axis correction factor.
Press 2 to enter the Y Axis correction factor.
Press 3 to enter the Z Axis correction factor.
26:08:11
1. X-Axis:
1.4
2. Y-Axis:
1.4
3. Z-Axis:
1.0
Select Axis
CANCEL
Figure 50 – Correction Factors
Enter the correction factor using the numeric keypad. The decimal point is
applied automatically.
Use the Left Arrow key
accept the inputted value. An Invalid input will give an 'Out of Range' error
message; the valid range is 1.0 to 2.0.
Press Soft Key 1 labelled CANCEL to discard any changes or Soft Key 4
labelled APPLY to make any changes made.
The correction factor is automatically applied to all displayed figures and results
where applicable.
09:19:00
CRITERION
APPLY
Numeric Entry Prompt
to delete unwanted input or press the OK key to
Page 50
26:08:11
1. X-Axis:
1.2
2. Y-Axis:
1.4
3. Z-Axis:
_.
Press OK to accept
CANCEL
09:19:02
CRITERION
Advertisement
Table of Contents
