Table of Contents
Advertisement
Real Time Operation
Real Time operation is extremely useful for pre-check range Overload / Under
range condiditons and can be identified by having a Duration value that does not
flash and is set to the value 00:00:00.
Display Modes
Depending on the variation of meter purchased, the following display modes are
available: -
HARM (H)
HARM
To switch between the modes of operation for multi function meters press Soft
Key 1 labelled MODE and a popup menu will appear with a list of selectable
display modes.
appropriate number on your keypad or press Soft Key 1 labelled CANCEL to
cancel the operation and return to the previous screen. Dedicated HARM and
SINGLE axis meters do not have this facility.
26:08:11
HARM
Range: 0.10 – 500 ms
X-Wh:
Y-Wh:
>
Z-Wh:
Duration: 00:00:00
< > to change parameter
MODE
RANGE
Figure 12 – Display Mode Selection
It is essential that whichever display mode is used for measuring vibration, that
the correct transducer is attached to your meter. Mismatched display modes
and
transducers,
measurements.
Chapter 5
SINGLE Axis (S)
Select which display mode you require by pressing the
09:00:30
Aeq
-2
0.123
0.124
0.125
RESET
SETUP
or
accelerometer
Page 21
SSINGLE
Range: 0.10 – 500 ms
X-Wh:
Y-Wh:
1. HARM
>
Z-Wh:
2. WBV
Duration: 00:00:00
3. Single
4. Custom
< > to change parameter
MODE
RANGE
sensitivities
Multi Function (M)
HARM
WBV
SINGLE
CUSTOM
09:00:32
26:08:11
HARM
Aeq
-2
0.123
0.124
0.125
RESET
SETUP
will
give
incorrect
Advertisement
Table of Contents
