Changing The Measuring Range; Figure 14 - Harm Range Selection Screens - Castle group Excieo GA2005H Operating Manual

Changing the Measuring Range

Each display mode on the Excieo meter has four ranges available. Switching
between the four ranges is achieved by pressing Soft Key 2 labelled RANGE.
The nominal delay time between changing a range and valid measurements
being displayed is 20 seconds, the displayed range is therefore highlighted for
approximately 20 seconds when the range is changed.
A complete list of ranges can be viewed under the heading Measuring Ranges
in Chapter 3.
Examples of the four parameter display screens for HARM are shown below: -
26:08:11
HARM
Range: 0.02 – 100 ms
X-Wh:
Y-Wh:
> Z-Wh:
Duration: 00:00:00
< > to change parameter
MODE RANGE
26:08:11
HARM
Range: 0.2 – 1000 ms
X-Wh:
Y-Wh:
> Z-Wh:
Duration: 00:00:00
< > to change parameter
MODE RANGE

Figure 14 - HARM Range Selection Screens

09:01:40
Aeq
-2
0.123
0.124
0.125
RESET SETUP
09:01:44
Aeq
-2
0.123
0.124
0.125
RESET SETUP
Page 24
26:08:11
HARM
Range: 0.10 – 500 ms
X-Wh:
Y-Wh:
> Z-Wh:
Duration: 00:00:00
< > to change parameter
MODE RANGE
26:08:11
HARM
Range: 1.0 – 5000 ms
X-Wh:
Y-Wh:
> Z-Wh:
Duration: 00:00:00
< > to change parameter
MODE RANGE
09:01:42
Aeq
-2
0.123
0.124
0.125
RESET SETUP
09:01:46
Aeq
-2
0.123
0.124
0.125
RESET SETUP