European Emc Directive - Comtech EF Data KPA080 Installation And Operation Manual

KPA080 Ku-Band Solid-State Power Amplifier

European EMC Directive

In order to meet the European Electro-Magnetic Compatibility (EMC) Directive
(EN55022, EN50082-1), properly shielded cables for DATA I/O are required. More
specifically, these cables must be shielded from end-to-end, ensuring a continuous
ground shield.
The following information is applicable for the European Low Voltage Directive
(EN60950):
International Symbols:
Note: For additional symbols, refer to "Cautions and Warnings" listed earlier in this
preface.
Rev. 0
<HAR> Type of power cord required for use in the European Community.
CAUTION: Double-pole/Neutral Fusing
!
ACHTUNG: Zweipolige bzw. Neutralleiter-Sicherung
Alternating Current.
Fuse.
Safety Ground.
Chassis Ground.
Preface
ix