Installation Check List - Hach ORBISPHERE G1100 User Manual

Installation

3.2 Installation check list

For a complete installation, proceed to the following actions following the instructions in this
manual very carefully:
1. Install the 410 analyzer. Refer to
2. Connect the G1100 sensor to the instrument. Refer to
3. Attach the sensor to the flow chamber, and then connect the flow chamber to the particle
filter and sample flow, ensuring that the sample outlet is directed to waste/drain. Refe to
Section 3.9.2 on page
4. Connect the calibration gas bottle ensuring the purity of the nitrogen gas is 99.999% or
better. Refer to
5. Turn the instrument on and set the operating language. Refer to
6. Set the security levels, users ID's and passwords. Refer to
7. If measuring in gas phase with fraction units (%, ppm), perform a barometric sensor
calibration. Refer to
8. Perform an initial gas sensor calibration using the manual zero calibration with auto-end
enabled. Refer to
9. Enable the auto-calibration feature. Refer to
calibration frequency. Refer to
The instrument should now be ready for operation. If a problem occurs, refer to
on page
who will be happy to assist you.
22
36.
Section 3.9.4 on page
Section 7.4 on page
Section 7.1.1 on page
99. If the difficulty cannot be overcome, please contact your Hach Lange representative
Section 3.3 on page 23
Section 3.9.1 on page
38.
61.
56.
Section 7.2 on page
Section 7.1.2 on page 57.
through 3.6 on page 30.
35.
Section 13.2 on page
Section 10 on page 85.
58. Set the auto
Troubleshooting
94.