Select Product; Modify Product - Hach ORBISPHERE G1100 User Manual

Products Menu

11.1.1 Select product

Note: If the PROFIBUS-DP communications protocol has been enabled, products can be selected for
analysis using that facility. Refer to
page 81

11.1.2 Modify product

88
Input/Output data on page 79
for detailed information.
Select the product (0-99) to be analyzed (oxygen gas
•
analysis only), or use the Next and Previous buttons to
scroll sequentially through the existing product list.
Alternatively, use the Search facility to search for a
product. Enter a full or partial search criteria. If only one
match is found, this product is automatically selected. If a
number of products match the search criteria, then a list
of matches will be displayed. Select a product directly
from the list of matching products.
Press OK to select the product or Cancel to exit.
Select the product (index 0-99) to modify, or use the Next
•
and Previous buttons to scroll sequentially through the
existing product list.
Alternatively, use the Search facility to search for a
product. Enter a full or partial search criteria. If only one
match is found, this product is automatically selected. If a
number of products match the search criteria, then a list
of matches will be displayed. Select a product directly
from the list of matching products.
Select the gas to analyze (up to three can be selected)
•
from the drop down list.
After selecting a product and gas, press Configure to
configure the product.
Configure the product as required. Refer to
•
configuration on page 50
Press Analog out to configure the analog outputs, OK to
accept the configuration as is, or Cancel to exit.
Configure the analog output as required. Refer to
•
configuration on page 67
Press OK to accept the configuration, or Cancel to exit.
and Change product command - output on
Measurement
for more information.
for more information.
Channel