Running Belt And Deck Replacement; About; Procedure - Precor GEN06 Series C952 Service Manual

Running Belt and Deck Replacement

About

This procedure provides instruction to remove and replace the Running Belt.
CAUTION: Two running belt gauges, Precor part number 20007-101, are required.
It is important that this procedure be followed to maintain correct drive belt and run-
ning belt tension. Improper tensioning of the belt will lead to premature running belt
wear, premature driver roller bearing failure and premature Take Up Roller bearing
failure.

Procedure

Review entire procedure before starting.
1. Switch the input power OFF and unplug the power cord.
2. Remove the front hood.
3. Remove the end cap and belt guard covers (see
ment" on page 46).
4. Remove the left and right deck trim covers
5. Remove the Take Up Roller, see
6. Remove the Drive Roller, see
7. Remove the four mounting bolts and the roller guard that hold the deck to the frame.
8. Lift the deck and running belt up and away from the treadmill.
9. If installed, remove the Auto Stop magnet from the deck, see
Replacement" on
(Undefined variable: TRM700-16Base.ServiceManualTitle)
"Take Up Roller Replacement" on
"Drive Roller Replacement" on
page 30.
5 Replacement Procedures
Running Belt and Deck Replacement
"End Cap & Belt Guard Cover Replace-
page 66.
page 42.
"Auto Stop Magnet
61