Connecting A Cd-Rom Drive; With Sampler Libraries - Roland XV-5080. Owner's Manual

Connecting a CD-ROM Drive

fig.07-005.e
XV-5080
1. Turn off the power of the XV-5080 and any connected
external devices.
2. Connect the XV-5080 and the CD-ROM drive with a SCSI
cable (one equipped with a 25-pin D-sub type connector
at the XV-5080 end).
3. Set the SCSI ID with the SCSI switch on the rear panel.
Any number is acceptable, as long as each device has a
different SCSI ID.
* For more on the CD-ROM drive SCSI ID settings, please refer
to the owner's manual for the device you are using.
The SCSI ID switch settings "8" and "9" cannot be used with
the XV-5080.
4. Set the CD-ROM drive's terminator to ON.
* For more on the CD-ROM drive terminator settings, please
refer to the owner's manual for the device you are using.
* For more on making SCSI connections, please refer to p. 239 of
the Owner's Manual.

With Sampler Libraries

1. Turn on the power to the CD-ROM drive and the XV-
5080.
2. Place the CD-ROM (sampler library) that you want to
load in the CD-ROM drive.
3. Press [DISK].
The Disk Menu page will appear.
4. Press [F1 (Load)].
The Load page will appear.
fig.07-006.e_70
5. Press [F1 (Drive)].
The Drive window will appear.
CD-ROM drive
SCSI
Cable
Chapter 7 Loading a Variety of Data
fig.07-007.e_70
The SCSI ID and Volume Label of the connected SCSI device
appear in the window.
6. Turn the VALUE dial to select the SCSI ID that was set
when the CD-ROM drive was connected.
7. Press [F6 (OK)].
The CD-ROM's contents are displayed.
* Items enclosed by <> indicate folders. Folders cannot be
loaded.
* The types of folders displayed vary depending on the library
being loaded. "Refer to "About the Sampler Library Folder
Types (Indication)" (p. 187).
[F5 (Refresh)]
Pressing this button clears the XV-5080's internal cache.
When sharing a Zip Drive with another XV-5080 (or
other device), be sure to press this button whenever
loading data from the other device concurrently being
used.
8. Turn the VALUE dial or press [
folder containing the file to be loaded.
9. Press [
], and the files available for loading will be
displayed.
* Press [ ] to move up one level in the hierarchy.
By pressing [F2 (View)], you can specify the category for files
to be displayed.
fig.07-008.e_70
Turn the VALUE dial or press [
category you want to load, and then press [F5 (On/Off)].
Press [F4 (All)] if you want to set markers in all files. Press
this once more to remove all markers. And then press [F6
(OK)] to finalize the category.
For more on category contents, refer to p. 188.
] or [ ] to select the
] or [ ] to select the
185