Roland XV-5080. Owner's Manual page 199

<Registering to Banks (Regstry)>
1. Press [DISK], lighting the indicator.
2. Press [F5 (Tool)].
3. Press [F5 (Regstry)].
The Card&Disk Card Registration page appears.
fig.08-05.e_70
* The amount of memory available in installed SIMMs, and the
size of samples on the card are displayed.
4. Press [
], [ ], [ ], or [
the bank to be used for registering.
5. Press [F1 (List)] to display the Sound File List page.
6. Turn the VALUE dial to select the file you want to
register, then press [F6 (OK)].
The registration is carried out.
* To cancel the operation, press [EXIT].
If no bank is available, you can select the files of a bank you
intend to erase, and press [F5 (Cancel)]. The registrations are
cancelled, and the bank is thus made empty and available.
Copying Files on One Memory Card to
Another Card (CardCpy)
You can take files stored on one memory card and copy them
to another memory card.
* The copy destination memory card must already be formatted.
Always be sure to follow the on-screen instructions when
inserting and removing cards during File Copy. Using a
different procedure or sequence may damage the card.
1. Press [DISK], lighting the indicator.
2. Press [F5 (Tool)].
3. Press [F6 (CardCpy)].
The Card&Disk Card Card File Copy page appears.
fig.08-06.e_70
Chapter 8 Saving Tones and Other Data You've Created
] to move the cursor to
4. After the page indicated in Step 4 appears, insert the card
containing the file you want to copy, then press [F6
(OK)].
5. Turn the VALUE dial to select the file you want to copy,
then press [F6 (Select)].
The following screen appears.
fig.08-07.e_70
6. When the screen shown above appears, insert the copy-
destination card and press [F6 (OK)].
fig.08-08.e_70
The contents of the copy destination card are displayed. Files
in the copy destination with "+" appearing before the file
names are shown at the top.
When you execute the copy after selecting the files with the
VALUE dial, then only the contents are overwrittem, with
the copy destination name remaining the same.
You can change the file name by pressing [F5 (Name)].
For details on assigning names, refer to <Renaming a File/
Folder (RENAME)> (p. 201).
* After naming the file, pressing [F6 (OK)] the executes the
copy.
7. Press [F6 (Copy)] to execute the File Copy, and the
following screen will appear.
* To cancel the copy, press [EXIT].
09.e_70
8. fIf you want to go on to copy any further files or other
data, press [F6 (Yes)]. To exit the operation, press [EXIT].
* No samples on the memory card are copied in this operation.
To copy samples, use the Sample Load procedure (p. 188) to
load the samples to the SIMM, then save them onto the card
(p. 196).
199