Roland XV-5080. Owner's Manual page 52

Chapter 2 Using the XV-5080 Effects
16: STEP FLANGER
The Step Flanger effect is a flanger in which the flanger pitch
changes in steps. The speed at which the pitch changes can
also be specified in terms of a note-value of a specified
tempo.
fig.2-19
Balance D
L in
Step Flanger
Feedback
Feedback
Step Flanger
R in
Balance D
Flanger
Rate (LFO Rate)
Adjust the rate of modulation.
Depth (LFO Rate)
Adjust the depth of modulation.
Fbk (Feedback Level) #
Adjust the amount (%) of the flanger sound that is returned
(fed back) into the input. Negative (-) settings will invert the
phase.
Feedback #
Adjust the amount (%) of the processed sound that is
returned (fed back) into the input. Positive (+) settings will
return the sound in phase, and negative (-) settings will
return the sound in reverse phase.
Phase
Adjust the spatial spread of the sound.
Pre Delay (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the flanger sound is heard.
Step Rate
Step Rate #
Adjust the rate (period) of pitch change. This parameter can
be set as a note-value of a specified tempo. In this case,
specify the value of the desired note.
EQ Gain
Low (LowGain)
Adjust the gain of the low frequency range.
52
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
High (High Gain)
Adjust the gain of the high frequency range.
Balance
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
flanger sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
chorus sound will be output.
Output
Level (Output Level)
Adjust the output level.
17: STEREO DELAY
This is a stereo delay.
When Feedback Mode is NORMAL:
fig.2-20
Balance D
L in
Delay
Feedback
Feedback
Delay
R in
Balance D
When Feedback Mode is CROSS:
fig.2-21
Balance D
L in
Delay
Feedback
Feedback
Delay
R in
Balance D
Delay
Left (Delay Time Left)
Adjust the time from the original sound until when the left
delay sound is heard.
Right (Delay Time Right)
Adjust the time from the original sound until when the right
delay sound is heard.
HF Damp
Adjust the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ