Selecting The Patch, And Setting The Volume, Pan, Pitch, And Polyphony - Roland XV-5080. Owner's Manual

Chapter 5 Creating a Performance
K.L (Part Keyboard Range Lower)
Range: C -1–G9
Specifies the lowest note that will cause the Part to play its
sound.
K.U (Part Keyboard Range Upper)
Range: C -1–G9
Specifies the highest note that will cause the Part to play its
sound.
The Lower value cannot be set to a value greater than Upper
value, or vice versa. If you attempt to do this, the two values
will change simultaneously.
U.F (Part Keyboard Fade Width Upper)
Range: 0–127
This determines what will happen to the Part's level when a
note that's higher than its specified keyboard range is
played. Higher settings produce a more gradual change in
volume. If you don't want the Tone to sound at all when a
note above the keyboard range is played, set this parameter
to 0.
Selecting the Patch, and Setting
the Volume, Pan, Pitch, and
Polyphony
PERFORMANCE Part #1 page
([PERFORM] - [F3 (Part)])
fig.05-007.e_70
Patch (Part Patch)
Type (Part Type)
Range: PAT/RHY
Selects the Patch (PAT) or Rhythm Set (RHY) the Part will
play.
Group (Part Group)
Available Settings:
Selects the group to which the desired Patch or Rhythm Set
belongs.
* You can also use the Patch Finder feature. (p. 19)
* You can also select from the FAVORITE LIST. (p. 207)
162
* It is not possible to select XP-A–H unless a wave expansion
board is inserted into the corresponding slot. (Quick Start; p.
3)
* It is not possible to select CARD unless a SmartMedia card is
inserted into the XV-5080 CARD slot.
Number
Selects the desired Patch or Rhythm Set by its number.
* You can also use the Patch Finder feature. (p. 19)
* You can also select from the FAVORITE LIST. (p. 207)
Level&Pan (Part Level&Pan)
Part Level
Available Settings:
Sets the volume of the Part. This setting's main purpose is to
adjust the volume balance between Parts.
Part Pan
Available Settings:
Specifies the stereo position of the Part's sound. L64 is far
left, 0 is center, and 63R is far right.
Tune (Part Tune)
Octave Shift (Part Octave Shift)
Range: -3– +3
Adjusts the pitch of the Part's sound up or down in units of
an octave (+/-3 octaves).
Coarse (Part Coarse Tune)
Range: -48– +48
Adjusts the pitch of the Part's sound up or down in semitone
steps over a range of +/-4 octaves.
Fine (Part Fine Tune)
Range: -50– +50
Adjusts the pitch of the Part's sound up or down in one-cent
steps (1/100th of a semitone) over a range of half a semitone
up or down.